歧管式微通道流动特性的研究

岐管式微通道(MMC)热沉具有热阻小、结构紧凑、冷却液流量小、流速低、沿流动方向温度分布均匀等优点.本文针对以去离子水为介质的岐管式微通道(宽W=100 μm,深H=300 μm)的流动特性进行了实验研究,实验的雷诺数范围为5O～3500.结果表明工质在微通道内流态由层流向紊流转变的临界雷诺数提前,此外数值模拟结果与实验值也吻合较好.最后在实验基础上,拟合出工质在层流和紊流下的流动阻力经验关联式.     

高能核碰撞中带电多重数快度与能量和中心度的关系

用强子–弦级联模型JPCIAE及相应的Monte Carlo事例产生器研究相对论性核–核碰撞中带电粒子多重数的赝快度密度对能量和中心度的依赖关系.无需另调任何模型参数的条件下,此模型可以同时较好地描述相对论性pp实验数据及PHOBOS和PHENIX实验组的Au+Au实验数据.本文指出:因〈N_part〉并非严格定义的物理量,致使实验上和理论上确定〈N_part〉有一定任意性,从而使得每参加者核子对的带电粒子赝快度密度随着〈N_part〉的增加可能逐渐增大,也可能逐渐减小,因此用它来区分粒子产生机制是欠妥的.     

The HITRAP project at GSI: trapping and cooling of highly-charged ions in a Penning trap

A decelerator will be installed at GSI in order to provide and study heavy nuclei without or with only few electrons at very low energies or even at rest. Highly-charged ions will be produced by stripping at relativistic energies. After electron cooling and deceleration in the Experimental Storage Ring (ESR) the ions are ejected out of the storage ring at 4 MeV/u and further decelerated in a combination of linear accelerator structures operated in reverse. Finally, they are injected into a Penning trap where the ions are cooled to 4 K by electron cooling in combination with resistive cooling. From here, the ions can be transferred in a quasi DC or in a pulsed mode to different experimental setups. This article describes the technical concepts of this project focused on the Penning trap.      

沿直线的垂直方向匀速直线运动的带电直线的电场

本文利用相对论变换关系计算了沿直线的垂直方向匀速运动的带电直线的电场.     

取压方式对微通道内单相摩擦阻力特性的影响

本文以去离子水和氮气为工质,在水平圆形微通道(dh=0．336 mm)中采用两种直接取压方式-缝隙取压和小孔取压,对单相摩擦阻力特性进行了实验研究,并通过改变缝隙宽度,研究缝隙宽度对压降测量偏差的影响．     

低速高电荷态离子40Ar16+与云母表面作用中的电子发射研究

报道了由兰州ECR源提供的低速高电荷离子40Ar16 入射到云母表面产生的电子发射的实验测量结果.结果发现,电子发射产额Y与离子入射角ψ有近似1/tanψ的关系.基于经典过垒模型,我们对这一关系进行了理论分析.实验结果和理论结果相当符合,这就间接说明势能电子发射是低速高电荷态离子作用于表面发射电子的一个主要途径.     

A high-current electron beam ion trap as an on-line charge breeder for the high precision mass measurement TITAN experiment

The precision of atomic mass measurements in a Penning trap is directly proportional to the charge state q of the ion and, hence, can be increased by using highly charged ions (HCI). For this reason, charge breeding with an electron beam ion trap (EBIT) is employed at TRIUMF’s Ion Trap for Atomic and Nuclear science (TITAN) on-line facility in Vancouver, Canada. By bombarding the injected and trapped singly charged ions with an intense beam of electrons, the charge state of the ions is rapidly increased inside the EBIT. To be compatible with the on-line requirements of short-lived isotopes, very high electron beam current densities are needed. The TITAN EBIT includes a 6 Tesla superconducting magnet and is designed to have electron beam currents and energies of up to 5 A and 60 keV, respectively. Once operational at full capacity, most species can be bred into a He-like configuration within tens of ms. Subsequently, the HCI are extracted, pass a Wien filter to reduce isobaric contamination, are cooled, and injected into a precision Penning trap for mass measurement. We will present the first results and current status of the TITAN EBIT, which has recently been moved to TRIUMF after assembly and commissioning at the Max-Planck-Institute (MPI) for Nuclear Physics in Heidelberg, Germany.     

The response of thermally and optically stimulated luminescence from Al2O3:C to high-energy heavy charged particles

The thermoluminescence (TL) and optically stimulated luminescence (OSL) response of Al₂O₃ dosimeters to high-energy heavy charged particles (HCP) has been studied using the heavy ion medical accelarator at Chiba, Japan. The samples were Al₂O₃ single-crystal chips, of the type usually known as TLD-500, and Luxel^TM dosimeters (Al₂O₃:C powder in plastic) from Landauer Inc. The samples were exposed to ⁴He (150 MeV/u), ¹²C (400 MeV/u), ²⁸Si (490 MeV/u) and ⁵⁶Fe (500 MeV/u) ions, with linear energy transfer values covering the range from 2.26 to 189 keV/μm in water and doses from 1 to 100 mGy (to water). A ⁹⁰Sr/⁹⁰Y beta source, calibrated against a ⁶⁰Co secondary standard, was used for calibration purposes. For OSL, we used both continuous-wave OSL measurements (CW-OSL, using green light stimulation at 525 nm) and pulsed OSL measurements (POSL, using 532 nm stimulation from a Nd:YAG Q-switched laser). The efficiencies (η_HCP,γ) of the different HCPs at producing OSL or TL were observed to depend not only upon the linear energy transfer (LET) of the HCP, but also upon the sample type (single crystal chip or Luxel^TM) and the luminescence method used to define the signal—i.e. TL, CW-OSL initial intensity, CW-OSL total area, or POSL. Observed changes in shape of the decay curve lead to potential methods for extracting LET information of unknown radiation fields. A discussion of the results is given, including the potential use of OSL from Al₂O₃ in the areas of space radiation dosimetry and radiation oncology.     

旋转带电体磁矩计算的若干法则与算例

本文在文献 [1]、[2 ]等的基础上给出关于旋转带电体的磁矩计算的若干法则 ,均以定理形式表达 ,并列表枚举其相关算例     

共轴均匀带电薄圆盘间的相互作用力

本文利用静电场的高斯定律和环路定律巧妙地求出了均匀带电圆盘在空间任一点所产生的电场 ,进而计算出了共轴均匀带电薄圆盘之间的相互作用力